Thursday, April 30, 2009

Coaming no 3


How difficult will it be?

Trials 1 and 2.

I think I will get the world's first kayak, whitout the cockpit.






Try 3.


I tryed with 7 mm thick and 40 mm high pine, the cracks a bit but as it is only in the outer annual ring.








Try 4.


Tried also with two 3-5 mm thick and 40 mm high. will see after the weekend if it has ruptured.

Monday, April 27, 2009

Kayak no 21


After the test paddle kayak has found it self down in the basement again.

At the top of the picture you can see the guides for the foot rests which I have glued in place.

I hav tryed to make a masik to get the coaming to get in the right position, it is not yet glued.



The broken cockpit coaming to test the final look, I think it will work.

Coaming no 2


This is the first attempt!
a little sad, I am.

But a little pity on the beautiful oak base. Now I have purchased a good piece of pine without knots will see if it goes better.

Thursday, April 23, 2009

Kayak no 20


Finally launching time!

It feels much more real now when the kayak has been known close to the water. That I was worried aboute the keel would be oblique, has just been wasted of energy.
The kayak went strait the hole time. I think however, that it is a little high in the water but it means that I can load it whit heavy luggage.





This picture was taken by my friend Micke HA who were there as a photographer, moral support, a lifeguard and generally nice friend.

Once we were about to pack up came a very nice Finnish man who wanted to show his strip built kayaks built of prints from. Thomasson design, incredibly fine work there.

Wednesday, April 22, 2009

Coaming no 1


I have changed little on the form since the first attempt. As material, I had a floor base of oak lying which fitted perfectly for the job. I cut it down to about 7 mm at the table saw. After about 12 minutes in my seam box it was time to get in shape, I had good help of my colleague André. It had never worked to make this by myself!

Steam box


Now it was time to use the "steambox" I've built. I have used a ventilation pipe Ø125 mm about 160 cm long. at one end, I screwed a piece of form plywood in the second, I have a loose piece that funktion as a lid. The pot is perhaps of 15 liters. Between the lid and the pipe, I have an old Thermos, it´s made to keep the heat on the content, so it should indeed be perfect in order not to lose the heat of the steam. All parts are lost and found.

I forgot the fact that I used som epoxy for sealing joints.










First try, one third of water in the pot, lid on and wait. Once water was boiling and it was about 90 ° C, I set my oak socket (more about that in another post)

Monday, April 20, 2009

Kayak no 19


It is approaching the big S day, S as in splash.
Tomorrow I will test paddle my kayak to see how it behaves in the water. I have in the absence of "saran wrap" wrapt the kayak in building plastic / moisture barrier. I hope it will hold.